There are 70 memories, numbered 00 - 69. To store a station into memory, first tune to that station. Then decide which of the memories to store it into. To store it, press-and-release the button labeled 'STORE', then, using the numbered Direct-Key-Input buttons, enter the memory number that you want it stored into (select from 00 - 69).

To access a station you have stored into memory, press-and-release button labeled 'MEMO' Note that the word 'MEMORY' appears in the display. Press the up/down tuning buttons (to the immediate left of the tuning knob) to advance through the memories. Or, if you know the specific memory number that you wish to access, Press 'MEMO', then, using the numbered Direct-Key-Input buttons, enter the memory number that you wish to access.

Turn on the radio. Quickly press-and-release the CLOCK button (this causes the clock to show in the display). Within 3 seconds, quickly press-and-release the CLOCK button repeatedly. When the letter 'L' appears, you have selected the local clock. When the letter 'L' does not appear in the display, you have selected the alternate time clock.

NOTE: This is a 24 hour clock, therefore 1 p.m. must be set to read 13:00.

1. Turn on the radio.
2. Select the local or alternate clock, whichever that you wish to set (see the separate FAQ, above).
3. Press the CLOCK button and do not release it until the colon between the clock digits flashes rapidly (about 3 seconds).
4. Use the Direct-Key-Input buttons to enter the time.
5. Press-and-release the CLOCK button.
   

Make sure that your antenna switch is in the correct position. When using the built-in antennas, the switch should be in the WHIP position. When using external FM antennas it should be in the 75 Ohm position. When using external SW or AM antennas, it should be in either the 50 or 500 Ohm position, depending on the type of antenna being used.